2: Dact-Ud Installation - Fire-Lite DACT-UD Manual

DACT-UD Installation
14
2.1.2 DACT-UD Installation
WARNING! Disconnect all sources of power (AC and DC) before installing or
removing any modules or wiring.
The DACT-UD module plugs into connector J2 on the MS-9600 main circuit board.
PH1
Primary
Phone Line
Primary Active LED
Kissoff LED
Figure 2.2 DACT-UD Module
The following steps must be followed when installing the DACT module:
1. Remove all power (AC and DC) from the FACP before proceeding with the
installation
2. Remove the Keypad/Display from the main circuit board as described in the
beginning of this section
Installation in MS-9600 FACP
PH2
Secondary
Phone Line
J1 Connector (located on back
of module) plugs into J2 on
MS-9600 main circuit board
DACT-UD PN 51899:B1 1/25/05
Secondary Active LED