GENERAL REMARKS General Remarks on blood pressure measurement For proper measurement of blood pressure • If the cuff is to be deflated quickly, depress “POWER” switch. • Take a deep breath five or six time and then relax before measur- •...
PRECAUTION FOR USE AND MAINTENANCE Nature and frequency of maintenance: Precautions for use This products is designed for use over an extended period of time; • If you suffer from heart disease, high blood pressure or other cir- culatory disease, please consult your doctor first. however, it is generally recommended that it be inspected every two •...
INSTALLING THE BATTERIES • To use this unit, you must install batteries, and also if battery mark “ ” will appear on the display, you must change two pieces of batteries. • After fastening the under hook, close the battery cover. •...
Page 6
MEASUREMENTS 1. Turn Power On SYSTOLICmmHg DIASTOLICmmHg PULSE/min After all display marks are disappeared, the last measured sys- tolic and diastolic blood pressure values are displayed. (Value of the pulse is not memorized nor displayed.) Memory function works on for approximately one second or during “POWER”...
Page 7
SYSTOLICmmHg DIASTOLICmmHg PULSE/min Wrist edge After three short buzzer beeps, the “0” appears on the display. Place the wrist cuff at the 1cm from the wrist edge. Then, ready for measurement. 2. Attaching of Wrist Cuff Wrist cuff Wrap the cuff around your wrist securely.
Page 8
SYSTOLICmmHg SYSTOLICmmHg DIASTOLICmmHg DIASTOLICmmHg PULSE/min PULSE/min Place your elbow on a table so that the palm is turned upwards and the cuff center is as high as your heart. Relax your entire body. SYSTOLICmmHg DIASTOLICmmHg 3. To Start the Measurement PULSE/min When inflation is completed, the automatically exhaust mecha- nism will gradually deflate the pressure in the “wrist cuff”, and...
5. Turn Power Off SYSTOLICmmHg Press the “Power Switch” to turn OFF. DIASTOLICmmHg 6. Automatic Power Off Function If this unit is left on after measurement, an Automatic Power- PULSE/min OFF Function turns the power OFF after approximately 3 min- utes.
DESCRIPTION OF DISPLAY MARKS DISPLAY MARK CONDITION/CAUSE CORRECTIVE ACTION Measurement is begun, but the pressure was insufficient. Repeat measurement again. Appears when the blood pressure could not be measured accu- rately. (Some noises were detected by the movement of arm during Repeat measurement again.
Page 11
CITIZEN is a registered trademark of Citizen Watch Co., Japan. Consumer Electronics Division CBM Bldg. 5F, 5-68-10, Nakano, Nakano-ku, Tokyo 164-0001, Japan Phone: (03)5345-7430 Fax: (03)5345-7431 E-mail: info-con@jcbm.co.jp...