Data Communications Between A Pv Unit And A Bn Unit - Casio PV-S250 User Manual

Notes
• The above procedures can be used to send or receive all data in specific
modes only. You cannot send or receive individual data items.
• Data communication can be interrupted at any time by pressing Esc.
This causes the message Stopped! to appear on the displays of both
units.
• The message Communication error! appears on the displays of both
units whenever data communication is interrupted due to cable
disconnection, line noise, or other abnormal condition.
• If the secret memory area is accessed on a unit receiving data, the received
data is stored in the secret memory area, regardless of the memory area
the data is in on the sending unit.
• Transferring data from the PV-S250/PV-S450 to a PV-100 or PV-200
causes all euro symbols to be replaced by spaces.
• The size of the PV-S250/PV-S450 screen is 160 · 160 dots. Transferring
PV-S250/PV-S450 Quick-Memo data to a PV-100 or PV-200, which
both have 98(V) · 124(H)-dot screens, causes the right side and bottom
part of the Quick-Memo image to be cut off in order to fit the PV-100/
PV-200 screen.
Data Communications Between a PV Unit and
a BN Unit
This section describes how to set up and communicate between a PV Unit and a
BN Unit (BN-10/BN-20 or BN-10A/BN-20A/BN-40A).
To connect a PV Unit to a BN Unit
1. Make sure that the power of both units is turned off.
2. Open the cover of the Mini Cradle port of the BN Unit, and connect its
Mini Cradle to the port.
3. Place the PV Unit onto its cradle.
• Gently but firmly press down on the PV Unit to ensure that it is inserted
into the cradle as far as it will go.
132