Table of Contents
Advertisement
7
Add detergent.
The percentage amounts in the display
help you to add the correct percentage
amount of detergent recommended by
the detergent manufacturer.
If the display shows:
40
Add 40 percent . . .
(slightly less than half)
50
Add 50 percent . . .
(half)
60
Add 60 percent . . .
(slightly more than half)
75
Add 75 percent . . .
(three quarters)
100 Add 100 percent . . .
. . . of the amount recommended by
the manufacturer.
Take the level of soiling and also the
water hardness into account. It is im-
portant to dispense the correct amount
because . . .
. . . too little detergent results in:
– Laundy not getting properly clean
and with time it may become grey
and hard to the touch.
– Greasy particles cling to the laundry.
– Limescale build up on heater ele-
ments.
. . . too much detergent results in:
– Excessive foam, which causes a low
level of agitation and poor wash,
rinse and spin results.
How to wash correctly
– High water consumption (an addi-
tional rinse cycle will automatically
switch in).
– A burden to the environment.
Pull out the detergent drawer and
place detergent in the compartments
as follows:
i = Detergent for pre-wash
(if selecting a pre-wash add 1/4 of the
total amount recommended).
j = Detergent for the main wash
including Soak.
§
= Fabric conditioner or liquid starch.
See "Detergent" section for further infor-
mation.
8
Open the stopcock.
If you do not want to select any of the
additional options (steps
proceed to step
9
!
to
)
§
.
21
Hide quick links:
Advertisement
Table of Contents
