HP Kayak XU800 Technical Notes page 4

Features
Feature:
Operating System
Main Memory
Maximum amount of
memory that can be
installed is:
2 GB (4 x 512 MB).
Mass Storage
SCSI Controller
IDE Controller
2 English
All models are preloaded with Windows NT® 4.0 SP5.
Models include either:
• Four RIMM sockets supporting RDRAM ECC memory modules
installed in pairs. Any unused RIMM sockets must contain a
continuity module.
Models are supplied with either 128 MB or 256 MB RDRAM ECC
main memory installed in pairs.
Memory upgrades are available in pairs of: 128 MB, 256 MB or 512
MB RDRAM ECC modules.
• Four DIMM sockets supporting SDRAM 100 MHz ECC memory
modules installed in pairs. Models are supplied with 128 MB of
SDRAM unbuffered ECC main memory.
Memory upgrades are available in 32 MB, 64 MB, 128 MB,
256 MB or 512 MB unbuffered 100 MHz ECC SDRAM modules.
Seven shelves supporting:
• Two front-access, third-height 3½-inch (one for the floppy disk
drive and one free) (height 1");
• Three front-access, half height, 5¼-inch drives (height 1.0");
Possibility to install a 3½-inch hard disk drive in one of the
5¼-inch shelves.
• Two internal 3½-inch hard disk drives (height 1.0").
SCSI Ultra 160m controller:
Adaptec® AIC-7892 Ultra-Wide 16-bit integrated SCSI controller
(160 MB/s).
The internal SCSI connectors allows for up to five internal devices to be
connected. Additional devices can be added outside the PC Workstation
by connecting directly to the rear panel SCSI connector. The external
connector allows up to ten external devices to be connected. This gives
a maximum of 15 (internal + external) devices that can be connected.
All models include an integrated Ultra ATA-66 controller that supports
up to four IDE devices
.
Description: