HP Kayak XA-s 02xx Handbook page 21

A
Beep Codes for the HP Kayak XM600
Beep
Pattern
— - - - - - - -
— - - - — —
— - - - — - - -
— - - - - - - —
— - - - - - - - —
— - - - - - - - - - -
— - - - - — —
- - — - - - - -
- - - - - - - —
— - -
1. Non-HP memory modules are not supported. Only HP memory modules should be used.
A-4 Beep, POST, and Error Codes
Beep Numeric
Code Code
1-2-2-3 16h
1-3-1-1 20h
1-3-1-3 22h
1-3-3-1 28h
1-3-4-1 2Ch
1-3-4-3 2Eh
1-4-1-1 30h
2-1-2-3 46h
2-2-3-1 58h
1-2 98h
Description
BIOS ROM Inform HP support/HP reseller
check-sum that system board is defective.
failure
DRAM refresh Check the memory is correctly
test failure1 installed. If the error still occurs,
replace the module.
8042 Inform HP support/HP reseller
Keyboard that system board is defective.
controller test
failure
Initialization Verify that memory or continuity
of RDRAM modules are installed.
has failed.
RAM failure Check the memory is correctly
on address installed. If the error still occurs,
1
line .... replace the module.
RAM failure Check the memory is correctly
on data bits installed. If the error still occurs,
....of low byte replace the module.
of memory
bus1
RAM failure Check the memory is correctly
on data bits installed. If the error still occurs,
....of high byte replace the module.
of memory
bus1
ROM Inform HP support/HP reseller
copyright that system board is defective.
notice check
failure
Unexpected Inform HP support/HP reseller
interrupts test that system board is defective.
failure
Video This can be caused by problems
configuration with the ROM on integrated
failure or video, an add-on video board or
option ROMs the ROM on a SCSI card.
check-sum
Inform reseller for the affected
failure
component.
Recommended
Action