Related Manuals for Caple Wi3113
Summary of Contents for Caple Wi3113
- Page 1 INSTRUCTIONS FOR WINE CELLAR Wi3113 Built-in Wi6222 Built-in For Spare Parts, Technical Advice or Product Service call the CAPLE HELPLINE on 0870 850 8734...
-
Page 2: Parts And Features
Thank you for buying your new CAPLE Wine Cellar. To ensure that you get the best results from your new purchase, we strongly suggest that you read this instruction manual thoroughly before use. This manual contains installation advice, usage instructions and other important facts about your CAPLE Wine Cellar. If treated with care, your CAPLE Wine Cellar should give you many years of trouble-free use. -
Page 3: Important Warnings And Advice
Ensure that you fully understand these instructions before operating this appliance. • Caple are NOT responsible for: - • 1. Damage caused by incorrect, mistaken or irrational use. 2. For any errors in this manual, or for any damage linked to or following the provision, performance or use of any wine cellar. -
Page 4: Installation Instructions
INSTALLATION INSTRUCTIONS BEFORE TURNING THE WINE CELLAR ON ENSURE IT IS PERFECTLY LEVEL. This should minimize any vibrations. Your cabinet is equipped with 4 adjustable feet. However, we recommend that you tighten the back feet to the maximum and then use the front feet to level the cabinet. IMPORTANT: WAIT 2 HOURS BEFORE TURNING THE WINE CELLAR ON FOR THE FIRST TIME. - Page 5 2. To remove 3 screws of right upper Hinge, then to remove right upper & Right lower hinges ; (See fig.C) 3. To use the screws which you removed From right side hinges to fix left upper & lower hinges (See Fig.D & Fig.E) 4.
- Page 6 Stainless Steel Plinth (Supplied separately) When the wine cellar is installed in its final position, the stainless steel plinth should be fitted. Remove the protective tape from the adhesive strips on the rear of the plinth and then place firmly in position onto the bottom of the wine cellar cabinet. THE FLOW OF AIR THROUGH THE GRILL MUST NOT BE OBSTRUCTED AT ANY TIME.
- Page 7 Installation of Shelves To fit or remove the shelf, tilt the shelf as per the diagram and simply pull out, or push the shelf in until it sits on the support brackets securely. NOTE: • If the unit is unplugged, if power is lost, or turned-off, you must wait 3 to 5 minutes before restarting the unit.
-
Page 8: Care And Maintenance
CARE AND MAINTENANCE Cleaning Turn off the power, unplug the appliance, and remove all items including shelves and • rack. Wash the inside surfaces with a warm water and baking soda solution. The solution • should be about two tablespoons of baking soda to one litre of water. Wash the shelves with a mild detergent solution. -
Page 9: Troubleshooting Guide
TROUBLE SHOOTING GUIDE You can solve many common wine cellar problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the service engineer. PROBLEM POSSIBLE CAUSE The appliance is not plugged in. - Page 10 DEFROSTING/CONDENSATION Your wine cellar is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cellar (interior rear wall) defrosts automatically. The defrost water is channeled into a drain pan which is located at the back of the wine cellar next to the compressor from where it evaporates.
Need help?
Do you have a question about the Wi3113 and is the answer not in the manual?
Questions and answers
Caple Wi3113 is warm not cold when switched on despite the temperature being set on the control panel for 12 degrees the temperature increases until its warm. The control panel does record the temperature increasing. Is there a part I can replace?