Advertisement

Quick Links

INSTRUCTIONS FOR USE

WINE CABINETS
WCI30B Slot-in
Wi3112 Slot-in
Wi6221 Slot-in
Wi6111 Slot-in
For Spare Parts, Technical Advice
or Product Service call the
CAPLE HELPLINE on 0870 850 8734
1 of 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WCI30B and is the answer not in the manual?

Questions and answers

Summary of Contents for Caple WCI30B

  • Page 1: Instructions For Use

    INSTRUCTIONS FOR USE WINE CABINETS WCI30B Slot-in Wi3112 Slot-in Wi6221 Slot-in Wi6111 Slot-in For Spare Parts, Technical Advice or Product Service call the CAPLE HELPLINE on 0870 850 8734 1 of 8...
  • Page 2: Important Warnings And Advice

    Thank you for buying your new CAPLE Wine Cabinet. To ensure that you get the best results from your new purchase, we strongly suggest that you read this instruction manual thoroughly before use. This manual contains installation advice, usage instructions and other important facts about your CAPLE Wine Cabinet. If treated with care, your CAPLE Wine Cabinet should give you many years of trouble-free use.
  • Page 3: Installation Instructions

    INSTALLATION INSTRUCTIONS BEFORE TURNING THE WINE CABINET ON ENSURE IT IS PERFECTLY LEVEL. This will minimise any vibrations. Your cabinet is equipped with 4 adjustable feet. However, we recommend that you tighten the back feet to the maximum and then use the front feet to level the cabinet. IMPORTANT: WAIT 2 HOURS BEFORE TURNING THE WINE CABINET ON FOR THE FIRST TIME.
  • Page 4 Stainless Steel Plinth (Supplied separately) When the wine Cabinet is installed in its final position, the stainless steel plinth should be fitted. Remove the protective tape from the adhesive strips on the rear of the plinth and then place firmly in position onto the bottom vents. THE FLOW OF AIR THROUGH THE GRILL MUST NOT BE OBSTRUCTED AT ANY TIME.
  • Page 5 Installation of Shelves (For WCi30B Wi3112 Wi6221) To fit or remove the shelf, tilt the shelf as per the diagram and simply pull out, or push the shelf in until it sits on the support brackets securely. Installation of Shelves (For Wi6111) Firstly remove both of the plastic posts with the Phillips screwdriver, then pull on onward direction to remove the shelf.
  • Page 6: Care And Maintenance

    STORAGE OF WINE The water reservoir should be positioned in the centre of the top rack in each compartment if used. To achieve maximum storage capacity, position the bottles alternately on the racks. (See below diagram) water reservoir CARE AND MAINTENANCE Cleaning •...
  • Page 7: Troubleshooting Guide

    TROUBLE SHOOTING GUIDE You can solve many common wine Cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the service engineer. PROBLEM POSSIBLE CAUSE The appliance is not plugged in.
  • Page 8: Humidity Maintenance System

    DEFROSTING/CONDENSATION Your wine Cabinet is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine Cabinet (interior rear wall) defrosts automatically. The defrost water is channeled into a drain pan which is located at the back of the wine Cabinet next to the compressor from where it evaporates.

This manual is also suitable for:

Wi6111Wi3112Wi6221

Table of Contents