Table Of Contents; Instruction For The User - Zanussi ZXS 646 IT Instruction Booklet

Built-in hob
Table of Contents

Advertisement

Contents
For the User
This appliance complies with the following
E.E.C. Directives:
-
2006/95 (Low Voltage Directive);
-
2004/108 (Electromagnetical Compatibility Directive);
-
90/396 (Gas Appliances Directive )
and subsequent modifications.

Instruction for the User

Once the hob has been installed, it is
important to remove any protective materials,
which were put on in the factory.
Hob burners control knobs
The hob burners control knobs are situated on the hob
right hand side. The symbols on the knobs mean that:
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a
pan on the pan support.
To light a burner, push in the relevant knob and
turn it counterclockwise to "maximum position".
After lighting the flame, keep the knob pushed
down for about 5 seconds. This will allow the
"thermocouple" (Fig. 1, lett. D) to be heated and
the safety device to be switched off, otherwise the
gas supply would be interrupted.
Then, check the flame is regular and adjust it as
required.
If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1, lett. A) and the
"crown" (Fig. 1, lett. B) are in the correct position.
To put the flame out, turn the knob to the symbol .
Always turn the flame down or put it out before taking
the pans off the burner.
Manual switch-on (in case of interruption of the
electric supply) : approached a flame to the burner
and push in the relevant knob and turn it
counterclockwise to "maximum position".
For the Installer
2
3
6
13
MANUFACTURER:
ELECTROLUX ITALIA S.p.A.
C.so Lino Zanussi 30
33080 Porcia (PN) - ITALIA
Fig. 1
Do not keep the control knob pressed for more
than 15 seconds.
If the burner does not light even after 15 seconds,
release the control knob, turn it the "off" position
and wait for at
least one minute before trying to light the burner
again.
FO 0204
A - Burner cap
B - Burner crown
C - Ignition candle
D - Thermocouple
7
7
8
9
10
11
12
3

Advertisement

Table of Contents
loading

Table of Contents