Canon WebView LivescopeMV LE User Manual page 22

(10) When switching to appropriate camera failed during assignment
Message
Cause
Action to
be taken
(11) Power to the camera is turned off or there is a malfunction
Message
Cause
Action to
be taken
(12) Incorrect address
Message
Cause
Action to
be taken
(13) Connection restrictions at the camera server
Message
Cause
Action to
be taken
(14) Maximum allowed number of camera server connections has been exceeded
Message
Cause
Action to
be taken
22
Could not switch camera.
An attempt was made to assign a camera that is different from the camera
being viewed by a client with control rights of a higher level than yourself.
Ask the other client to release the control privilege.
Camera is switched off or faulty.
Power to the camera is off, or a cable is not properly connected.
• Turn on power to the camera.
• Connect the cable.
Could not connect to the camera server.
Network connection was cut, power to the camera server was cut, or the proxy
settings are not correct.
• Re-connect to the network.
• Turn on power to the camera server.
• Redo the proxy settings.
Your computer is not authorized to access the camera server.
Access restrictions have been set at the camera server.
Release the access restrictions.
Number of accesses to the camera server has reached to the maximum.
The number of access to the camera server has been reached.
Try accessing the camera server later.