Canon VB150 User Manual page 27

●A010 Camera control driver start and stop (info)
%1 driver for camera [%2] %3
Message
Camera type (Canon NU-700 | Canon VC-C3 | Canon VC-C4 | Canon VC-C4R)
%1
Camera number (1-4)
%2
started | stopped
%3
The camera control device was detected and the driver started up, or a camera
Explanation
control device error was detected and the driver stopped.
●A011 Camera control device error (warning)
%1 [%2] malfunction (%3)
Message
Camera type (Canon NU-700 | Canon VC-C3 | Canon VC-C4 | Canon VC-C4R)
%1
Camera number (1-4)
%2
Error (read | write | timeout | ...)
%3
Camera control device I/O error.
Explanation
Response There is a malfunction if it does not reset automatically. Contact an authorized
Canon service representative.
●A012 WebView Livescope client start and stop (info)
%1@%2 %3
Message
Client type (LS/C | LS/D | LS/H)
%1
Client host IP address
%2
connected | closed
%3
Explanation WV-TCP camera control client (LS/C), WV-TCP video transmission client (LS/D),
WV-HTTP client (LS/H) started or stopped.
●A014 Access prohibited due to host restriction (notice)
LS@%1 access denied
Message
Client host IP address
%1
Explanation Access from the client was denied due to host restrictions.
●A016 Amount of transmitted video data (info)
%1@%2 %3 frames/%4 bytes in %5 seconds
Message
Client type (LS/D | LS/H)
%1
Client host IP address
%2
%3 Number of frames
Number of bytes
%4
Video transmission time
%5
Explanation This shows the results of video transmission for a video transmission client.
24