Canon VB150 User Manual page 35

●S005 System settings changed (info)
System settings updated
Message
The VB software settings were modified without a reboot.
Explanation
●S006 IP address conflict detection at startup (err)
Detected a conflict for IP address %1 with %2
Message
IP address
%1
Ethernet address
%2
Explanation An IP address conflict was detected during startup. If there is a device running on
the network that has the same IP address as the VB150, this error occurs when
the VB150 starts up.
Response Change the VB150 IP address or change the IP address of the conflicting network
device. If you change the VB150 IP address, the VB150 must be rebooted.
When there is an IP address conflict, it may not be possible to modify the settings
via Ethernet. In this event, an initial setup tool must be used to change the settings.
●S007 IP address conflict detected during operation (err)
Duplicate IP address. %1
Message
Ethernet address
%1
Explanation An IP address conflict was detected during operation. This occurs when a network
device with the same IP address as the VB150 is started up after the VB150 was
started up.
Response As for S006.
●S010 FAT (File Allocation Table) count error (err)
only 2 FATs are supported (FATs=%1)
Message
Number of FATs
%1
The number of FATs is not 2. The file system may be corrupted or it may not be
Explanation
formatted as a FAT file system.
Response If this error affects the internal file system, contact an authorized Canon service
representative. If it affects a memory card, replace the memory card.
●S011 Cluster size error (err)
cluster size is zero.
Message
The size of clusters is zero. The file system may be corrupted or it may not be
Explanation
formatted as a FAT file system.
Response If this error affects the internal file system, contact an authorized Canon service
representative. If it affects a memory card, replace the memory card.
Log Messages
32