Canon SmartBase MPC400 Service Manual page 166

SmartBase MPC600F/MPC400 Chapter 4: Maintenance & Service
##nnn
START TIME
OTHER PARTY
MAKER CODE
RCV V.8 FRAME
SYMBOL RATE
TX LVL REDUCTION : 0 (Fixed)
ERR ABCODE
ERR SECTXB
ERR SECRXB
RX/TX
NOTE
Figure 4-38 System Dump List (2/2)
: Service error code
: Communication start date and time (on 24 hour clock)
: Telephone number sent from other party
: Maker code
[1000 1000] Indicates a Canon fax
: Received V.8 protocol signal
: Symbol rate used for the primary channel
: Code output by the modem when an error occurred (Not used in the
field)
: Transmit status of the modem when an error occurred (Not used in the
field)
: Received status of the modem when an error occurred (Not used in the
field)
: Received/transmitted protocol signal
bit 1 to bit 96 of received/transmitted DIS, DCS, or DTS
If no service errors have occurred in the past, the above report will not be output.
lower nibble
upper nibble
4-82