Cannot Connect To The Network Wirelessly; You Forgot Airstation's Ssid, Encryption Key, Or Password; The Link Speed Is Slower Than 300 Mbps (Maximum Link Speed Is Only 150Mbps) - Buffalo AirStation Nfiniti WZR-HP-G300NH User Manual

Chapter 6 Trouble Shooting

Cannot connect to the network wirelessly.

• Configure your wireless client with the same SSID, encryption type, and encryption key as set
on the AirStation.
The factory defaults are:
SSID -
Encryption Type -
Encryption Key -
• Place your AirStation and wireless devices 2 - 10 feet apart.
• Restart your AirStation.
You forgot AirStation's SSID, Encryption Key, or
Password.
Hold down the Reset button on the base of your AirStation for 3 seconds to initialize its settings. All
settings, including your password, SSID, and encryption key will be initialized to their defaults. The
factory defaults are:
SSID -
Encryption Type -
Encryption Key -
The link speed is slower than 300 Mbps (Maximum
link speed is only 150Mbps).
By default, the AirStation's 300 Mbps mode is not enabled. You may enable it with the following
procedure:
1. Open the configuration utility (chapter 4).
2. Click [Wireless SSID & Channel (11n 300Mbps Mode)] in Easy Setup.
3. Change the value in [300Mbps Mode] - [Band Width] to 40 MHz and click [Apply].
If you still cannot connect at 300 Mbps, check the settings of your wireless client device.
WZR-HP-G300NH User Manual
The AirStation's MAC address (printed on the label)
WPA/WPA2 mixed mode - PSK (Connect with either WPA-PSK TKIP or
WPA2-PSK AES).
Printed on the label of the AirStation (if not, the AirStation is not
encrypted in the default configuration.)
The AirStation's MAC address (printed on the label)
WPA/WPA2 mixed mode - PSK (Connect with either WPA-PSK TKIP or
WPA2-PSK AES).
Printed on the label of the AirStation (if not, the AirStation is not
encrypted in the default configuration.)
105