Cannot Connect To The Network Wirelessly; You Forgot Airstation's Ssid, Encryption Key, Or Password; The Link Speed Is Slower Than 300 Mbps; Is Only 130 Mbps) - Buffalo NFINITI High Power WZR-300HP User Manual

Chapter 6 Trouble Shooting

Cannot connect to the network wirelessly.

• Configure your wireless client with the same SSID, encryption type, and encryption key as set
on the AirStation.
The factory defaults are:
SSID -
Encryption Type -
Encryption Key -
Note: For details, refer to the Setup Card.
• Place your AirStation and wireless devices 2 - 10 feet apart.
• Restart your AirStation.
You forgot AirStation's SSID, Encryption Key, or
Password.
Hold down the reset button on the base of your AirStation for 3 seconds to initialize its settings. All
settings, including your password, SSID, and encryption key will be initialized to their defaults.
The link speed is slower than 300 Mbps (Maximum
link speed is only 130 Mbps).
By default, the AirStation's 300 Mbps mode is not enabled. You may enable it with the following
procedure:
1. Open the configuration interface (chapter 4).
2. In Easy Setup, click [Wireless SSID & Channel].
3. Change the value in [300 Mbps Mode] - [Bandwidth] to 40 MHz and click [Apply].
If you still cannot connect at 300 Mbps, check the settings of your wireless client devices.
BUFFALO-XXXXXX (the last 6 digits of the AirStation's MAC address)
WPA/WPA2 mixed mode - PSK (Connect with either WPA-PSK TKIP or
WPA2-PSK AES).
Printed on the Setup Card.
- 102 -