Table of Contents
Advertisement
*3
If you want to print paper of 115 to 120 g/m
*4
If either setting causes the following problems etc., specify the other setting to print.
- Output paper curls.
- Residual images appear on non-printed areas.
- The toner does not fix onto paper well, and the printing comes out faint.
*5
Specify [
paper (75 to 90 g/m
IMPORTANT
Be sure to match the type of the loaded paper.
If the setting for the paper type is different from that of the loaded paper, this may result in
crucial damage to the printer.
Be sure to match the setting in the printer driver.
Normally, you do not need to change the settings for the printer driver because the
default setting for [Paper Type] in the printer driver is set to [Printer Default].
If you want to change the settings for the printer driver, match the setting and [
If they do not match, the message <
In this case, the setting for [
pressing [
For users who do not use the printer driver
When you are printing from an operating system on which you cannot use the printer
driver (such as MS-DOS and UNIX), match the setting for [
type of the loaded paper.
When [
The printer performs printing without checking the paper settings in the printer driver.
Make sure that the paper specified in the printer driver matches that loaded in the paper
cassette before using the printer.
1
Press [
2
Select [
[OK].
32
] for this item when a paper jam occurs or when you want to improve the fixation on printing coarse
2
) with [
] selected.
] in the control panel.
] (
), allowing you to continue printing.
] is specified
] (
2
, you can specify either of [
] is changed to that in the printer driver by
).
] using [
*4
] or [
].
> appears.
] and [
], and then press
] and the
Advertisement
Table of Contents
