Description Of The Panel Functions - Canon RE-350 Control Interface Commands Manual

1.2 Description of the Front and Rear Panel Functions
Button/
Key
Control Knob
RS-232
2
†
CONTROL
(Button)
INPUT
3
SELECT
(Button)
NEGA
4
(Button)
WHITE BAL.
5
AUTO
(Button)
WHITE BAL.
6
MANUAL
(Control Knob)
Switches the mode from [O
Mode to [O -L ] Mode.
N INE
In the [O -L ] Mode the
FF INE
on line'. In the [O -L ] Mode or [N
N INE
"Event Data Packet" for 'Request off line'.
[O -L ] Mode
FF INE
The will reject the
RE-350
Mode command or the [N
to [O -L ] Mode when it is to be controlled from the front panel. The
FF INE
will be off.
LED
[O -L ] Mode
N INE
The will reject every input from the front panel except from the {
RE-350
†
Control} button and will accept only
The will be on.
RS-232 LED
[N ] Mode
(Used in [
OTIFICATION
The reports the condition of each button/control knob pressed to the
RE-350
using the "Event Data Packet". Each
"Command Data Packet" from the
The only function which can respond is manual operation of the {
Selects the input video signal or document camera signal to send to the video output
terminal (Composite Video and S-video).
Negative/Positive conversion toggle button. Toggles the video output between
positive and negative.
Press to set the white balance automatically. This tries, for
white balance position, if the proper position is not found, the White Balance Auto
will be turned off to show that no proper white balance position was found.
LED
Note: The will Auto White Balance once at start-up.
RE-350
Adjusts the color balance.
The resulting auto white balance position will be used as the center value for this
control knob. The color will shift to blue when this control knob is turned right, and
to red when turned left. This control knob will operate under Positive and Negative
mode. This control knob does not work while the
† The {RS-232 Control} button will be referred to as the {RS-232} button.
Function
-L ] Mode to [O -L
N INE FF
will send the "Event Data Packet" for 'Request
RE-350
] Mode the
OTIFICATION
commands from the
RS-232
] Mode command. The
OTIFICATION
command data packets from the
RS-232
] Mode only.)
O -L
N INE
function will be controlled by the
RE-350
.
PC
RE-350
] Mode or from [O -L
INE FF
will send the
RE-350
except for the [O -L
PC
N
should be set
RE-350
RS-232
RS-232
PC
} button.
RS-232
seconds, to find a proper
6
is auto focusing.
]
INE
]
INE
.
PC
4