Canon RE-350 Control Interface Commands Manual page 13
Video visualizer
Hide thumbs
Also See for RE-350:
- Instruction manual (23 pages) ,
- Brochure & specs (4 pages) ,
- Pin assigments manual (1 page)
Table of Contents
Advertisement
1.3.4 Procedure for Using the {RS-232} Button
Function of {
} button
RS-232
By pressing this button, toggles the
another controller device.
Once the
detects that the {
RE-350
through the
to tell the PC that the operator is trying to change the mode.
RS232C I/F
The Event data packet will differ according to the
Current Mode
OFF
ON
Notification
Note:
1. The
will shift its mode after the
RE-350
The
can not shift its mode to [N
RE-350
Mode, the PC has to give the <Notification> command to the
2. After the {
} button is pressed and before the mode of the
RS-232
mode transition. To tell this transition status to the operator, the
is in this transition, every button, control knob or command from the
from active to inactive for communication with the
RE-350's RS232C I/F
} button was pressed, the
RS-232
's current mode.
RE-350
LineRequest ON Line
LineRequest OFF Line
Request OFF Line
receives an <Accepted> E-response data from the
RE-350
] Mode directly. In order to set
OTIFICATION
will send an Event data packet to the
RE-350
The Kind of Event-data-packet
RE-350
while in [O
L
] Mode.
RE-350
N
INE
is determined, the
RE-350
's
will blink. While the
RE-350
RS-232 LED
, will be disregarded.
PC
or
PC
PC
.
PC
to [N
]
OTIFICATION
will be in a
RE-350
RE-350
13
Advertisement
Table of Contents
