Clutch Lever - Yamaha FZS10Y Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
4
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12400
/ " Start switch "
" for the high Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
EAU12460 gine.
/ "
The engine trouble warning light will
". When re- come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
Hazard switch "
With the key in the "ON" position, use
EAU12500
this switch to turn on the hazard lights
(simultaneous flashing of all turn signal
lights).
EAU12660 The hazard lights are used in case of
/ "
an emergency or to warn other drivers
" before starting
when your vehicle is stopped where it
" to
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12711
"

Clutch lever

EAU41700
1. Clutch lever
EAU12765
" The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
ECA10061 tion circuit cut-off system. (See page
4-21.)
4-10
EAU12820