Yamaha XT250Z Owner's Manual page 53

7. Remove and replace the oil filter
element and O-rings.
TIP
Make sure that the O-rings are properly
seated.
2
1. Oil filter element
2. O-ring
8. Install the oil filter element cover by
installing the bolts, then tightening
them to the specified torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
9. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
PERIODIC MAINTENANCE AND ADJUSTMENT
10. Install the oil filter element drain
bolt, and then tighten it to the spec-
ified torque.
Tightening torques:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
11. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
bolt.
1
Recommended oil:
2
See page 9-1.
Oil quantity:
Without oil filter element replace-
ment:
1.20 L (1.27 US qt, 1.06 Imp.qt)
With oil filter element replacement:
1.30 L (1.37 US qt, 1.14 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
G
In order to prevent clutch slip-
12. Start the engine, and then let it idle
13. Turn the engine off, and then
ECA11620
7-15
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
check the oil level and correct it if
necessary.
2
3
4
5
6
7
8
9