Bulldog Security RS92 Installation And Owner's Manual page 6

CHASSIS GROUND
Locate an easy to get to bolt or screw
located under the driver's side of the dash and
attach the BLACK ground wire from the 11-pin
harness securely as pictured.
PARKING LIGHTS (+12V only with parking lights on)
Turn the parking lights to the ON position. (NOT YOUR HEADLAMPS).
Probe the wire(s) coming from your headlamp control switch.
Find a wire that will show +12V only when the parking lights
are ON. Connect the BROWN wire from the 12-pin harness to this
wire. If this wire tests as a (-) negative, see diagram above.
BRAKE INPUT
The brake wire is located on the switch near and above the brake pedal. The correct wire will show
+12V on the test light only when the brake is pressed. Connect the ORANGE from the 12-pin harness
to this wire.
FACTORY ALARM SHUT DOWN WIRE (FASD) (-)
If your vehicle is equipped with a factory alarm system (as most vehicles with a factory keyless
entry are) probe for a small gauge wire (usually found in the driver's side kick panel) that shows
(-) ground when the door lock cylinder is turned to the unlock position using the key. This wire
will usually show a (+) positive voltage before turning the key. NOTE: Some factory disarm wires
remain neutral before you turn the key to unlock instead of +12v positive. Connect the WHITE WITH
RED STRIPE wire from the 12-pin harness to this wire.
HOOD PIN SWITCH
This feature will keep the engine from starting or shut off the engine when the hood is opened.
Locate a good chassis ground, if at all possible do not install the pin switch in the rain gutter.
Drill a 5/16 hole, insert the pin switch into the hole and tighten. Check for the hood adjustment,
there is approximately 1/4" adjustment in the pin switch. Close the hood easy, making sure that
the pin switch is not keeping the hood from closing all the way, if it does, cut off approximately
1/8" of the black plastic off of the top of the hoodpin switch and try closing the hood again.
Check to make sure that the hoodpin switch remains neutral when the hood is closed and shows ground
when the hood is open. Plug the BLUE WITH WHITE STRIPE wire from the 12-pin harness into the bottom
of the hood pin switch.
TACH INPUT (Optional)
By this time, you should have determined the way you want your vehicle to start (tach or tachless).
If you have chosen the TACHLESS start option, simply proceed to the next step and skip the following
connection instructions. Make sure to tape the GREEN WITH BLACK STRIPE wire up if not used. For
TACH mode connect the GREEN WITH BLACK STRIPE wire from the 12-pin harness to the negative side
of the coil or the tach wire at the coil pack under the hood. To find the coil pack follow the
spark plug wires back to the termination point. To operate in tach mode, make sure to program tach
option, see programming tach option page 8.
HORN HONK OUTPUT (-) (Optional part #775 required)
The horn wire is usually located in the ingition switch
harness. This wire will test as a ground (-) when the
horn is honked. An optional relay is needed to make this
connection. Connect the GRAY wire from the 12-pin harness
to this relay.
Factory Bolt
Spade Connector
NEGATIVE PARKING LIGHT OUTPUT
Optional part #775 required.
Black Ground Wire
YELLOW
WHITE
Brown wire
from 18 pin
harness
BLUE
RED
DO NOT USE THE RED WIRE, TAPE OFF.
YELLOW
WHITE
87a
Gray from
12-pin
harness
BLUE
RED
Note: Remove any paint below
the spade connector.
To (-)Parking
Light Output
BLACK
87a
To Ground
To Ground
To Horn output
wire in vehicle
BLACK
12V constant
fused at 10
amps
To Ground
5