Mounting Under A Continuous Worktop; Rehingeing The Door - Electrolux Santo 1573TK-4 Operating Instructions Manual

Mounting under a continuous worktop

If installed under a continuous
worktop, the appliance is fastened
with a mounting screw (A) under
the panel.

Rehingeing the door

The side at which the door opens can be changed from the right side
(factory adjustment) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the
1
appliance may not be connected to the mains. Remove plug from the
mains beforehand.
0 Tilt the appliance slightly towards
the rear and drop it securely.
0 Unscrew the door hinge screws (K)
and take the door bearing (1)
downwards out of its cavity.
0 Open the door a little way and take
it out downwards.
0 Unscrew the upper pin (A) and srew
it into place on the opposite side.
0 Fit the door into the upper pin (A)
and close it.
0 Insert the pin of the door bearing
(1) into the left hand cavity and
screw the bearing firmly into place
with the screws (K).
Installation
9