Do not store any containers with flammable materials, such as spray cans, fire extinguisher refill cartridges etc. in the refrigerator. Maintenance and Cleaning ¥ Before cleaning, always switch off the appliance and disconnect from the electrical supply.
At the end of the Appliance Life ¥ When disposing of your appliance use an authorised disposal site. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
Do not cover the shelves with any protective material, such as paper, cardboard or plastic, which may obstruct the air circulation through them. To help you use your refrigerator correctly, here are some more useful hints: Raw meat (beef, pork, lamb & chicken or poultry): wrap in polythene bags and place on top of the salad bin.
Groceries Drawer (only for ERN 2372) Some models have a groceries drawer mounted on rollers above the fruit and vegetable trays. When stored here groceries are more easily accessible. The groceries drawer may be removed: ¥ Pull the groceries drawer fully forwards then lift it upwards and remove.
22¡C in an hour between the supermarket and home. It then took 11 hours to get down to 7¡C in the refrigerator. ¥ Keep the refrigerator door closed as much as possible. ¥ Do not push food together too much, try to allow air to circulate around each item.
Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. Important To avoid defrost water overflowing into the...
Something not Working? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom No power to appliance The light does not come on...
Customer Care Department For general enquiries concerning your Electrolux appliance or for further information on Electrolux products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.electrolux.co.uk...
Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: ¥...
Technical specifications POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY (*) GROSS CAPACITY NET CAPACITY (*) This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located. Installation Warning IF YOU ARE DISCARDING AN OLD...
Door reversal The applianceÕs door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet.
Electrical Connection WARNING THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted.
Building in Dimensions of the recess ERN 1673 Height of housing (1) Depth of housing (2) Width of housing (3) It is necessary that the cabinet has a ventilation recess with the following dimensions: Depth 50 mm Width 540 mm...
Page 15
4. Snap vent grill (B) and hinge cover (E) into position. Apply blanking covers (C-D) as indicated. PR266 5. Separate parts Ha, Hb, Hc, Hd figure. ca. 50 mm ca. 50 mm 6. Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes.
Page 16
PR168 10. Place the small square on the guide again and fix it with the screws supplied. Should the alignment of the furniture door be necessary, use the clearance of slots. At the end of this procedure, it is necessary to check if the door of the furniture closes properly.