Table of Contents
Advertisement
Prior to Initial Start–Up
0 Please clean the appliance interior and all accessories prior to initial
start-up (see section: "Cleaning and Care").
Electrical Connection
Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.
WARNING – THIS APPLIANCE MUST BE EARTHED
1
The manufacturer declines any liability should these safety measures
not be observed.
Before switching on, make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate. The rating plate is
inside, on the left.
The appliance is supplied with a 13 amp plug fitted. In the event of
having to change the fuse in the plug supplied, a 13 amp ASTA
approved (BS 1362) fuse must be used.
Important
The wires in the mains lead are coloured in accordance with the
following code:
Green and YellowEarth
Blue Neutral
BrownLive
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings indentifying the terminals in
your plug, proceed as follows:
1.The wire coloured green and yellow must be connected to the
terminal marked with the letter „E" or by the earth symbol
green and yellow.
2.The wire coloured blue must be connected to the terminal „N" or
coloured black.
3.The wire coloured brown must be connected to the terminal marked
„L" or coloured red.
4.Upon completion there must be not cut, or stray strands of wire
present and the cord clamp must be secure over the outer sheat.
Warning! A cut-off plug inserted into a 13 amp socket is a serious
1
safety (shock) hazard. Ensure that the cut-off plug is disposed of safely.
or coloured
11
Advertisement
Table of Contents
