Post (Power On Self Test) Error Messages - HP bc1000 - Blade PC Reference Manual

4.2 POST (Power On Self Test) Error Messages

Message
101-Option ROM Checksum
Error
102/103-System Board error
162-System Options Not Set
163-Time & Date Not Set
164-Memory Size Error
201-Memory Error
303-Keyboard Controller Error
304-Keyboard or System Unit
Error
1720-SMART Hard Drive
detects immanent failure
1780-Disk 0 Failure
Service Reference Guide bc1000 and bc1500
POST Error Messages
Health
LED
Red • Clear CMOS
• Flash ROM if necessary.
• Replace the blade.
Red • Clear CMOS.
• Replace the blade.
Amber • Set time and date in Computer Setup.
• Replace the RTC battery.
Amber • Set time and date in Computer Setup.
• Replace the RTC battery.
Amber • Ensure DIMMs are properly installed.
• Verify proper DIMM type.
• Remove and replace modules one at a time to
isolate faulty module.
• Replace blade.
Red • Ensure DIMMs are properly installed.
• Verify proper DIMM type.
• Remove and replace modules one at a time to
isolate faulty module.
• Replace blade.
Amber • Reconnect keyboard with blade turned off.
• Try different keyboard.
• Replace blade
Amber • Reconnect keyboard with blade turned off.
• Replace keyboard.
• Replace blade.
Amber • Run Drive Protection System test if applicable.
• Apply firmware patch (www.hp.com/support).
• Back up contents and replace the hard drive.
Amber • Run Computer Setup IDE self test from Computer
Setup.
• Replace hard drive.
352971-005
Corrective Action
.
Diagnostics
4–3