Table of Contents
Advertisement
Pre-Lift Operation Notes and Details
Lift Features (continued)
ing the DOWN switch deploys
(unfolds) the roll stop. The roll
stop is cylinder powered to
automatically fold (rotate) to the
vertical position when the UP
switch is pressed (roll stop
raises before platform raises).
Read warning posted on
Fully Unfolded Roll Stop (Ramp position)
Page 18
opposite page. Discontinue
lift operation immediately if
the roll stop does not operate
properly.
Roll Stop Latch: A spring-
loaded latch engages the
outboard roll stop when the roll
stop rotates upward from the
ramp position to the vertical
Outboard Roll Stop
Disengaged
Fully Engaged
Roll Stop Latch
Roll Stop
Latch
Note: Platform must raise
approximately two inches
before latch engages fully.
position (UP switch is pressed
to raise the platform above the
ground). Note: The platform
must raise approximately two
inches before the latch engages
fully (see photos below).
The latch disengages the roll
stop when the platform lowers
fully (reaches ground level) and
Fully Folded Roll Stop (Up-vertical)
2"
Latch Foot
Advertisement
Table of Contents
