Table of Contents
Advertisement
Pre-Lift Operation Notes and Details
the latch foot contacts the
ground (latch raises above the
roll stop).
Outboard Roll Stop and Roll
Stop Latch Operation: The
operator (attendant) must press
the DOWN switch to lower the
platform fully to the ground.
The attendant must view the
W ARNING
Discontinue lift use
immediately if any lift
component does not
operate properly.
Failure to do so may
result in serious
bodily injury and/or
property damage.
platform as it lowers to be
certain the entire platform
reaches and rests safely on the
ground (see photo below). Stop
pressing the DOWN switch if
any portion of the platform is
obstructed while descending or
the entire platform does not
reach ground level for any
reason (contact with an ob-
The attendant must view the
platform as it lowers to be
certain the entire platform
reaches and rests safely on
the ground.
struction, mechanical failure,
exceeding the lift "floor-to-
ground" capacity, etc.).
After the platform is fully low-
ered (entire platform reaches
ground level), the attendant
should continue to press the
Page 19
Advertisement
Table of Contents
