Brother HL-7050 Service Manual page 60

CHAPTER 2 INSTALLATION AND BASIC OPERATION
4.5 Printing to the Face up Output Tray (Face up printing)
When the face up output tray is open, the printer has a straight paper path from the paper tray
or MP tray through to the back of the printer. Use this output method when you want to print on
special media that is thick or should not be bent, such as thick paper, labels, card stock or
envelopes.
(1) Open the face up output tray.
(2) Pull out the face up output tray extension.
(3) Put the paper in the paper tray or the MP tray.
(4) After the printer ejects all the printed pages, remove them and close the face up output
tray.
4.6 Manual Feed
If paper is placed in the MP tray when the setting MANUAL FEED = ON has been set in
PAPER mode using the control panel, the printer will load paper only from the MP tray.
NOTE:
When feeding paper manually, note the following:
If the application software supports a manual feed selection in the print menu, it can be
selected through the software. Since the software or command setting overrides the
switch setting, it is unnecessary to set the MANUAL FEED mode and the paper size with
the PAPER mode.
When using pre-printed paper in the MP tray, the paper should be inserted top edge (Top
of the paper) first with the pre-printed side face up.
2-30
Fig. 2-50
Fig. 2-51