Brother HL-7050 Service Manual page 51

(2) Pull out the MP extension flap.
(3) When loading paper in the MP tray, make sure
it touches the back of the tray and remains
below the limit mark.
NOTE:
Make sure that the neatly stacked paper is correctly seated on the MP tray, otherwise paper
may not be fed correctly, resulting in a skewed printout or a paper jam.
(4) While pressing the paper guide release lever,
slide the adjuster to fit the paper size.
When printing on special paper such as
envelopes, thick paper, labels and so on, open
the face up output tray to print face up. See
'Printing on Envelopes' or 'Printing on Label,
Transparency, etc.' in this chapter.
NOTE:
When placing paper on the MP tray, note the following:
When printing, the inside tray automatically rises to feed paper into the printer.
The print surface must be face up.
Insert the leading edge of the paper first and push it gently into the tray.
The top of the paper stack must be under the guides that are on both sides of the tray.
The maximum thickness is 10 mm (or 0.39 inch).
(5) Change the settings in the printer driver.
2-21
HL-7050 SERVICE MANUAL
Fig. 2-28
Fig. 2-29
Fig. 2-30