Transfer Unit - Brother 1660E Service Manual

1.30 Transfer Unit

(1) Loosen a screw.
(2) Release the 3 right hooks, (see Figure 4.57) lift the right part of the unit ( A ) and slide it to
the right ( B ) to take off the left part from the main chassis L. Remove the transfer unit from
the body by lifting the former.
Main chassis L
(3) Open the transfer base hook and take off the left bearing (white) from the hook ( A ). Lift the
left side ( B ), slide it to the left ( C ) and take off the roller shaft from the right bearing (black) ( D ).
(4) Remove the transfer roller assy.
Caution : Do not touch the sponge rubber roller when replacing the transfer roller (the roller with
hand grease or clasped too strongly may result in poor printing quality).
A
Screw
Figure 4.56
A
B
Transfer roller assy
Figure 4.57
Transfer base assy
D
C
IV - 22
Transfer unit
Right
3 Hooks