6 ] Removing The Mechanical Unit Together With The Cutter-Related Components - Brother PT-2500PC Service Manual

[ 6 ] Removing the Mechanical Unit Together with the Cutter-related Components

(1) Remove the screw from the grounding wire.
(2) Remove the screw that secures the mechanical unit to the bottom cover.
(3) Disconnect the following from the main PCB:
- Tape feed motor harness (P5)
- Cutter sensor harness (P3)
- Cutter motor harness (P4)
- Head flat cable (P8)
NOTE: Gently handle the harnesses and flat cable.
(4) Take the mechanical unit together with the cutter-related components up and out of
the bottom cover.
Fig. 2.2-13 Removing the Mechanical Unit Together with Cutter-related Components
II - 17