2 ] Installing The Power Supply Pcb - Brother PT-2300 Service Manual

[ 2 ] Installing the Power Supply PCB
(1) Fit the positive (+) and negative (-) terminals of the battery power cords into the bottom
cover.
Note 1: When handling those terminals, do not grip the cords but the terminal plates.
Note 2: Route the battery power cords through the two ribs provided on the bottom cover.
(2) Stick the pad onto the rib on the bottom cover. (The double-faced adhesive tape is provided
on the pad.) (PT-2300/2310)
(3) Secure the power supply PCB to the bottom cover with one screw.
Tightening torque: 392±98 mN•m (4±1 kg•cm)
(PT-2300/2310)
Power supply PCB
Grounding wire
Power supply harness
USB/IF harness
(PT-2450)
Power supply PCB
Grounding wire
Power supply harness
(Refer to Fig.2.2-21.)
Screw
Screw
Fig. 2.2-20 Installing the Power Supply PCB (1)
Positive (+) terminal
Negative (-) terminal
Pad
Positioning pin
Bottom cover
Core
Positive (+) terminal
II- 24
Pad
Rib
Negative (-) terminal
Positioning pin
Bottom cover