Brother FAX560 Service Manual page 131

Error Code
(Hex.)
( 82xx
( 8303
( 8809
( 880B
( A301
( A302
( A303
( A304
( A307
( A308
NOTE: Four-digit error codes listed above are preceded by MACHINE ERR instead of MACHINE
ERROR.
Error codes in parentheses do not appear in the "MACHINE ERR _ _ _ _," since those errors are displayed as
messages described in "[ 1 ] Error messages on the LCD."
maintenance mode (Function code 82). If an equipment error occurs during communications, they appear in
the communications error lists.
Although recording paper has been fed by 150 mm after the start of recording, the
registration sensor is still OFF. )
Although recording paper has been fed by 360 mm after the start of recording, the
registration sensor is still ON. )
Before the start of paper feeding, the registration sensor is already ON. )
The registration sensor is ON when you turn the power on or after you open and
close the control panel ASSY.
In document scanning, the document front sensor goes OFF although the document
rear sensor is still OFF. )
In document scanning, the document rear sensor is still OFF although a document
has passed through the document front sensor. )
In document ejecting caused by any of the following, the document front sensor goes
OFF but the document rear sensor remains OFF:
- Depression of the STOP key in midway of scanning.
- Illegal copying (Copying a document longer than the recording paper or making an
enlargement copy larger than the recording paper).
- Recovery operation from the error state (e.g., "DOCUMENT JAM" and "CHECK
PAPER" error.)
In document ejecting caused by any of the following, the document rear sensor sticks
to OFF:
- Depression of the STOP key in midway of scanning.
- Illegal copying (Copying a document longer than the recording paper or making an
enlargement copy larger than the recording paper).
- Recovery operation from the error state (e.g., "DOCUMENT JAM" and "CHECK
PAPER" error.)
In document scanning, the document rear sensor remains ON although the document
has been fed by the specified amount after the document front sensor went OFF. )
In document ejecting caused by any of the following, the document rear sensor
remains ON although the document has been fed by the specified amount after the
document front sensor went OFF:
- Depression of the STOP key in midway of scanning.
- Illegal copying (Copying a document longer than the recording paper or making an
enlargement copy larger than the recording paper).
- Recovery operation from the error state (e.g., "DOCUMENT JAM" and "CHECK
PAPER" error.)
Error factor
You can display those error codes in the
VI - 4