Multi-Control Lever - Honda Ridgeline Owner's Manual

1. OFF
2. INT: Intermittent
3. INT TIME ring
4. LO: Low speed
5. HI: High speed
6. MIST
7. Windshield washers
8. Turn signal
9. High beams
10. Flash high beams
The multi-control lever has many
functions, including windshield
wipers and washers, turn signals,
headlight high beams, and headlight
high beam flashing.
To select a position, turn the rotary
switch, push the button on the end of
the lever, or push the lever up, down,
forward, or backward.
OFF: The wipers are not activated.
INT: The length of the wiper
interval is varied
automatically according to the
vehicle's speed.
Vary the delay by turning the
INT TIME ring. If you turn it
to the shortest delay, the
wipers change to low speed
when the vehicle speed
exceeds 12 mph (20 km/h).

Multi-Control Lever

LO The wipers run at low speed.
HI The wipers run at high speed.
The wipers run at high speed
MIST:
until you release the lever.
Push the
Windshield Washer:
button on the end of the
multi-control lever. The
washers spray until you
release the button. The
wipers run at low speed, then
complete one more sweep
after you release the button.
75