Honda Ridgeline Owner's Manual page 262

2007
Hide thumbs Also See for Ridgeline:
Table of Contents

Advertisement

Lights
4.
Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
5.
Install the rubber weather seal
over the back of the headlight
assembly. Make sure it is right
side up.
6.
Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
256
Replacing a Front Turn Signal/
Hazard/Parking Light Bulb
1.
To change the passenger's side
bulb, start the engine, turn the
steering wheel all the way to the
left, and turn off the engine. To
change the driver's side bulb, turn
the steering wheel to the right.
HOLDING CLIPS
2.
Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
3.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
4.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ridgeline 2007

Table of Contents