Multi-Control Lever - Honda 2008 Ridgeline Owner's Manual

Main Menu
1. OFF
2. INT: Intermittent
3. INT TIME ring
4. LO: Low speed
5. HI: High speed
6. MIST
7. Windshield washers
8. Turn signal
9. High beams
10. Flash high beams
Table Of Contents
The multi-control lever has many
functions, including windshield
wipers and washers, turn signals,
headlight high beams, and headlight
high beam flashing.
To select a position, turn the rotary
switch, push the button on the end of
the lever, or push the lever up, down,
forward, or backward.
OFF: The wipers are not activated.
INT: The length of the wiper
interval is varied automatically
according to the vehicle's speed.
Vary the delay by turning the
INT TIME ring. If you turn it to
the shortest delay, the wipers
change to low speed when the
vehicle speed exceeds 12 mph
(20 km/h).
2008 Ridgeline

Multi-Control Lever

LO The wipers run at low speed.
−
The wipers run at high speed.
HI −
The wipers run at high speed
MIST:
until you release the lever.
Windshield Washer: Push the
button on the end of the
multi-control lever. The
washers spray until you
release the button. The
wipers run at low speed, then
complete one more sweep
after you release the button.
CONTINUED
75