Alpine CDA-7878R Owner's Manual page 39

Adjusting/Storing the CROSSOVER/TIME CORRECTION
Adjusting
1
Select the Crossover mode from the table above.
2
Press the ENTER button to activate the
Adjusting mode.
3
Press the BAND button to select the channel
(LPF/HPF) that you want to adjust.
4
Press the g DN or f UP button to select
the cut-off frequency.
5
Press the 8 or 9 button to select the Slope.
To adjust more channels, repeat steps 3 to 5.
6
Press the ENTER button to activate the
Adjusting level mode.
7
Press the BAND button to select the channel you
want to adjust.
8
Press the 8 or 9 button to adjust the level.
To adjust more channels, repeat steps 7 to 8.
9
Press the ENTER button to activate the Time
Correction Adjusting mode.
10
Press the BAND button to select the channel
that you want to adjust.
11
Press the 8 or 9 button to adjust the Time
Correction. To adjust more channels, repeat
steps 10 to 11.
Storing the settings
12
Press and hold the ENTER button for more than
2 seconds to flash the display.
13
Press the 8 or 9 button to select the preset
number (1 to 2) that you want to store.
14
Press the ENTER button to store the adjustment.
Store other adjustments, repeat the procedures
above.
15
Press the A.PROC button to return to normal
mode.
37
-EN