Configuring Wep - NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
• To configure WPA with RADIUS, see
• To configure WPA2 with RADIUS, see
page 2-37.
• To configure WPA and WPA2 with RADIUS, see
RADIUS" on page
• To configure WPA-PSK, see
• To configure WPA2-PSK, see
• To configure WPA-PSK and WPA2-PSK, see
on page 2-42.
8. Wireless Client Security Separation is disabled by default. If enabled, the associated
wireless clients will not be able to communicate with each other.
9. If the hubs/switches on your LAN support the VLAN (802.1Q) standard and this feature has
been enabled, the default VLAN ID for WNDAP350 will be associated with each profile. The
default Profile VLAN ID must match the IDs used by other network devices.
10. Click Apply to save your Security Profile settings.
11. Click Back. Your new settings will appear in the Security Profiles table identified by the
Profile Name of the profile. A VLAN ID will also be assigned to your profile.
Note: Security Profiles that share the same type of network authentication need not
share the same passphrase or keys.
To enable your Security Profile:
1. Check the radio box in the Enable column next to your profile.
2. Click Apply. Your Security Profile will be enabled. If you enabled VLAN 802.1Q, your
VLAN Profile will also be enabled. (See
VLAN 802.1Q.)

Configuring WEP

To configure WEP data encryption:
1. From the Network Authentication drop-down menu, choose either Open System or Shared
Key authentication.
Basic Installation and Configuration
"Configuring WPA with RADIUS" on page
"Configuring WPA2 with RADIUS" on
2-38.
"Configuring WPA-PSK" on page
"Configuring WPA2-PSK" on page
"Setting Basic IP Options" on page 2-13
v1.1, November 2009
"Configuring WPA and WPA2 with
2-40.
2-41.
"Configuring WPA-PSK and WPA2-PSK"
2-35.
to enable
2-33