Importing Rogue Ap List From A File - NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
1. Under the Configuration tab on the main menu, select Security, select Advanced from the
sidebar, and then select Rogue AP. The Rogue AP screen displays, as shown in
below.
Figure 3-14 Enable Rogue AP detection
2. Check the Turn Rogue AP Detection On radio box to enable rogue AP detection and click
Apply.
If you enable Rogue AP Detection, the AP continuously scans the wireless network and
collects information about all APs heard on its channel.
3. You can Import AP List from a File. See
for more information.
4. Under the Unknown AP List, click Refresh to discover the APs.
5. Click Move to add any AP to the Known AP List.
6. Click Delete to remove an AP from the Known AP List.
7. Click Apply to save your change.

Importing Rogue AP List from a File

To replace the existing AP list:
3-18
"Importing Rogue AP List from a File" on page 3-18
v1.1, November 2009
Figure 3-8
Management