Maintenance And Care - Bissell OptiClean Multi Cyclonic 30C7 Series User Manual

M
aintenance and care
cleaning the pre-motor filter
the pre-motor filter should be
checked often and washed as
needed to maintain performance.
More or less frequent cleaning may
be required based on individual
vacuuming habits and types of
debris picked up.
1. Unplug the vacuum from electrical outlet.
2. The pre-motor filter protects the motor from
dirt particles. It is located in the slide out
tray underneath the dirt container. If the
filter becomes dirty, pull out the tray, lift
out the foam filter pad and clean it.
note: the pre-motor filter may
be hand washed in cold water
with mild detergent. Rinse well
and air dry thoroughly before
replacing.
Replacing the post-motor filter cartridge
the post-motor filter assists in the
filtration process to return clean air
to the room. it is located under the
pre-motor filter tray. unit must be
reclined to locate the post-motor
filter.
the post-motor filter cartridge
should be replaced if machine
performance is noticeably declining.
More or less frequent replacing may
be required based on individual
vacuuming habits and types of
debris picked up.
1. Recline the vacuum.
2. While holding the handle at a 60° angle,
push the button on the top of the post-
motor filter door to unlatch. Remove the
door. Post motor filter door is located
directly below the pre-motor filter drawer.
3. If the filter is dirty, remove it and replace
with a new filter.
4. Replace the post-motor filter door.
note: the post-motor filter is
a white, pleated filter. this fil-
ter is not washable and must
be replaced when it becomes
dirty.
10
w w w . b i s s e l l . c o m
WaRning:
Do not operate cleaner
with damp or wet filters
or without all filters in
place.
2
2
8 0 0 . 2 3 7 . 7 6 9 1