Bissell OptiClean Multi Cyclonic 30C7 Series User Manual page 9

O
perations
empty dirty container
empty the dirt container as soon as the
dirt reaches the "full" line on the side of
the container.
1. Unplug the vacuum from electrical outlet.
2. Slide the Lock 'n Seal Lever to the
"unlock" position.
3. Grasp the handle and pull the dirt container
straight out to remove from the vacuum.
4. Empty dirt into garbage container.
note: emptying the dirt container
after every use will help prevent
over filling and ensure that the
vacuum is ready to go the next time
you clean.
cleaning the dirt container
additional steps can be taken to
clean the dirt container as necessary.
1. Ensure dirt container has been emptied.
2. While the dirt container is still out of the
unit, grasp the inner cyclone screen and
twist counterclockwise until the locking
tabs stop the rotation. Pull down the inner
cyclone screen to remove it.
3. Clean the inner cyclone with a cloth or
soft brush to remove dust or debris.
4. Wipe out the inside of the upper tank and
the inner cyclone with a damp cloth
moistened with water or a mild cleaning
solution. Let completely dry before next
use.
5. If desired, the lower dirt container may be
washed in warm water. Make sure it is
completely dry before reassembling.
do not put in the dishwasher.
6. To reassemble, replace the inner cyclone
screen by sliding it into the upper tank
and rotating clockwise until the locking
tabs stop the rotation. The inner cyclone
screen is labeled front and back. When
properly assembled the front graphic
should face out.
w w w . b i s s e l l . c o m
2.
WaRning:
To reduce the risk of
electric shock, turn
power switch OFF and
disconnect polarized
plug from electrical
outlet before performing
maintenance or
troubleshooting checks.
2
8 0 0 . 2 3 7 . 7 6 9 1
4
9