Stop And Go; Safety Features - Black Widow Security BW RAS 651 System Manual

STOP AND GO

The Stop and Go feature allows the vehicle to
remain running without use of the ignition key
during short stops.
To activate the Stop and Go feature:
1. Make sure the engine is running.
2. Press button 3.
3. Turn ignition off.
• The doors will unlock.
• The parking lights will turn on.
• The engine will remain running.
4. Exit the vehicle and lock the doors using
transmitter button 1.
To resume driver control:
1. Unlock the doors by pressing transmitter
button 2.
2. Turn on the ignition.
• The vehicle resumes driver control,
when the brake pedal is pressed.
AUTO COLD START
This feature allows the system to start and run
the vehicle every 2, 3, or 4 hours (user
selectable) for up to 12 starts. This allows the
engine to remain at an operational temperature
in extremely cold weather. Auto Cold Start
interval timing must be chosen during
installation.
Engaging the Auto Cold Start feature:
LED AND PARKING LIGHT
Parking Light
3 Slow Flashes
5 Slow Flashes
5 Flashes
5 Flashes
7 Flashes
LED Indication Problem
On Solid System in Valet Mode
No Flashes Key is on during remote start attempt
5 Flashes Open hood warning (before start)
5 Flashes System shut down using brake pedal (when running)
7 Flashes Tachometer lock out (see dealer)
To turn Auto Cold Start on:
1. Press and hold buttons 1 & 3 together for
3 seconds.
• The parking lights will turn on for 10
seconds to confirm activation.
2. Press the button corresponding to the
desired start cycle interval:
Button 2 = start every 2 hours
Button 3 = start every 3 hours
Button 4 = start every 4 hours
• The parking lights will flash a number
of times equal to the chosen interval.
Disengaging the Auto Cold Start feature:
Any of the following actions will cancel the
Auto Cold Start feature:
Press and hold buttons 1 & 3 together for 3
seconds.
• The parking lights will flash twice and
the horn will honk twice (optional) to
confirm deactivation.
Press the brake pedal.
Turn ignition on.

SAFETY FEATURES

The System will not start the vehicle if the
brake pedal is pressed, if the hood is open, or if
the system is in Valet mode.Also, if the brake is
pressed or the hood is opened while remote
running, the remote start will shut down.
INDICATIONS
DIAGNOSTIC
3
- or -
- or -