Advertisement
• Pin 1 - Defeat Relay 1 Input. Locate the vehicle
starter and verify correct operation of the circuit
using a multimeter. Cut this wire then verify that the
vehicle does not crank. Connect the key side of the
wire to Pin 1. Connect the opposite wire to Pin 2.
• Pin 2 - Defeat Relay 1 Output. See Pin 1 description.
• Pin 3 - Ground input (-). Connect to a solid chas-
sis ground that is clean and free of paint or dirt.
• Pin 4 - Ignition input (+). Connect to the main igni-
tion wire that switches +12V and does not drop out
during cranking.
• Pin 5 - +12V Battery Input. Connect the red fused
wire on the main harness to a constant +12V source.
• Pin 6 - Defeat Relay 2 Input. Defeat Relay 2 can be
used for an additional circuit defeat such as a fuel
pump relay. This allows multiple points of protection.
• Pin 7 - Defeat Relay 2 Output. See Pin 6 description.
• Pin 8 - Horn Honk output (-). Connect to a relay
to honk the vehicle's horn or flash the parking lights
for Arm, Disarm, and Anti-Carjacking indications.
• Pin 9 - Dome Light output (-). Connect to a relay
for dome light activation. This wire may also be pro-
grammed as a Factory Alarm Disarm Output.
• Pin 10 - Optional Defeat 3 Output (-). Connect to
a relay for optional circuit defeat. When the unit acti-
vates the circuit disable relays, this wire provides a
ground output to activate a 3rd circuit defeat such as
ignition.
Plug in Connectors:
3-Pin White Connector: Plug-in connector port for
door lock harness or optional door lock relay mod-
ule (PDLM-3).
• BLUE WIRE - negative unlock output (-).
• RED WIRE - +12V low current output (+) for relay
modules, or inverters. 100mA relay trigger only. Do
NOT use as a power source for door lock relays.
• GREEN WIRE - negative lock output (-).
2-Pin Red Connector: Plug-in connector port for
LED. Mount LED in an area where it may be easily seen
from either side of the vehicle.
2-Pin Blue Connector: Plug-in connector port for
Valet switch. Mount the switch in an area that is easi-
ly accessible from the driver's position.
System Operation
ARMING OPERATION
To arm the system manually, press the transmitter
button.
• The horn will chirp once.*
• The doors will lock.*
• The starter and other selected circuits will be
disabled.
• The LED will start flashing slowly, indicating the
system is armed.
* If Installed
If the ignition is turned on while the system is armed,
the Ignition Trigger will begin honking the horn for 30
seconds. Press the transmitter button or use the
Emergency Override procedure to disarm the system.
PASSIVE ARMING
The Passive Arming feature allows the system to arm
automatically after turning off the ignition.
To arm the system passively turn off the ignition:
1.
After 5
seconds:
• The LED will start flashing quickly to indicate
the system is about to arm.
2.
After 10 seconds:
•
The horn will chirp once.
• The doors will lock.
• The LED will flash slowly to indicate that the
system is armed. The system can also be
armed at any time by pressing the transmitter
button.
NOTE: The system may be armed at any time by
pressing the transmitter button. If the Auto Transmit
Mode is enabled, the Passive Arming feature will be
delayed until the trasmitter is out of range.
DISARMING OPERATION
To disarm the system press transmitter button.
• The horn will chirp twice.
• The doors will unlock.
2
Advertisement
