Advertisement
Quick Links
Passive Vehicle Immobilizer System
Owner / Installation Manual
Standard Features
The system has the following standard features:
• (2) 1-button remote controls
• Two Built-in relays for starter and/or fuel system
disable
• LED indicator
• Valet switch
• Passive or active arming
• Ignition trigger
Optional Features
The system has many optional features that may require
additional parts and/or labor.
• Remote keyless entry (Door lock/unlock)
• Optional third circuit defeat output
• Illuminated entry
• Horn honk
• Anti-carjacking
• Selectable parking light/horn output
Adding or Deleting Remote Controls
Follow the steps below to code a replacement trans-
mitter into the system (maximum of 4). If there are
less than 4 transmitters, code the last transmitter
multiple times to fill all 4 transmitter slots and force
any lost or stolen transmitters out of the system.
To enter Code Learning Mode:
1. Turn ignition key on, off, on, off, and leave on
within 5 seconds.
• The LED will will flash 3 times.
2. Press and hold the valet switch for 2 seconds.
• The LED will will flash 5 times.
3. Release the valet switch.
4. Program all desired remotes by pressing the
button on each of the transmitters.
• The LED will will flash after the system has
5. Turn off the ignition.
Wiring Diagram
1
learned each transmitter.
Advertisement
Related Manuals for Black Widow Security BW IM 1
Summary of Contents for Black Widow Security BW IM 1
-
Page 1: Wiring Diagram
Passive Vehicle Immobilizer System Owner / Installation Manual Standard Features Adding or Deleting Remote Controls The system has the following standard features: Follow the steps below to code a replacement trans- mitter into the system (maximum of 4). If there are •... -
Page 2: System Operation
• Pin 1 - Defeat Relay 1 Input. Locate the vehicle 2-Pin Blue Connector: Plug-in connector port for starter and verify correct operation of the circuit Valet switch. Mount the switch in an area that is easi- using a multimeter. Cut this wire then verify that the ly accessible from the driver’s position. - Page 3 • The optional illuminated entry feature will turn HORN CHIRPS For audible confirmation of the ARM and DISARM on the dome light for 30 seconds (if programmed functions, the horn can be programmed to chirp. This for Factory Alarm Disarm,the system will pulse the feature requires the optional horn output to be connected, factory disarm wire).
-
Page 4: Remote Programmable Features
emote Programmable Features: Step Function On (Default) Ignition Lock Passive Unlock Normal/Silent Arming Silent Normal Door Unlock Pulse Single Double Door Lock Pulse Length .75 Seconds 3 Seconds Wire #9 Output on Disarm Dome Light Output Factory Alarm Disarm Anti-Carjack Feature Enabled Disabled Remote Programmable Features...