Assembly Guide - Nautilus NS300X Assembly Manual

6
2
5
Before assembling this gym, please be aware that this piece of equipment can be assembled in two different configurations.
The Weight Stack can be assembled on either side of the gym depending on what best fits your living space. This is accomplished simply by
assembling the Rear Frame (2), Top Stack Support Frame (8), and Calf Raise / Low Pulley Frame (7) on the opposite side of the machine.
This gym is supplied with an instructional work out diagram which is to be adhered to the Rear Frame (2) back panel. See note in diagram above
for recommended location.
The following assembly instructions show the gym assembled with the weight stack on the left side. To assemble the gym with the weight stack on
the right side, simply assemble the Rear Frame (2), Top Stack Support Frame (8), and Calf Raise / Low Pulley Frame (7) on the opposite side of
the machine as shown in the instructions.
Be sure to place the NS 300X gym as close to its final location before adding weight plates. The gym is designed so that the rear of the frame can
sit directly against a wall. Please allow a minimum of 24" on each side of the gym from the nearest wall or obstruction. The weight stack side of
the gym will need a minimum of 48" from any obstruction. If an attachment such as a leg press is used now or in the future, please allow for 48" on
the side opposite the weight stack.
8
ASSEmBLY
Recommendedlocationfor instructional
workout diagram .
NS300X Press Arm
6
2
5