Miele W 931i Operating Instructions Manual page 43

Fitting a plinth facia
The appliance plinth below the door
can be partially concealed using a
plinth facia.
The height and return of the appliance
plinth cannot be altered.
A taller plinth facia can only be in-
stalled if the overall niche height is
higher.
Plinth height 100 mm (standard)
Niche height: 820 mm
Plinth height 150 mm
Niche height: 870 mm - a spacer frame
is required.
Plinth height 200 mm
Niche height: 920 mm - two spacer
frames are required.
A plinth facia (600 mm long) can be or-
dered from your kitchen Dealer or
manufacturer. For Miele kitchens
please quote the model number when
ordering.
Before fitting the plinth facia, please
note:
Under no circumstances must the
flap(s) in the appliance plinth be
stuck over.
Fitting the plinth facia:
Stick the velcro fasterner provided to
the appliance plinth.
For this the following procedure is rec-
ommended:
Match up the hooked side and the
looped side of the velcro fastener
lengthwise.
Cut into 2 or 3 pieces.
Peel off the protective backing from
one of the velcro fastener pieces.
Position the cut pieces along the ap-
pliance plinth, at the left and right
hand edge, and in the middle, avoid-
ing the drain flaps. Press firmly into
place.
Now peel the protective backing off
the other velcro fastener piece.
Address the plinth facia to the ad-
hesive backing and press firmly into
place.
Washer-dryer Stack
A Miele tumble dryer can be stacked
with this washing machine. A stacking
kit* and special accessories* are
necessary.
* All parts marked * are available from
the Miele Spare Parts or Sales depart-
ments and from some Miele Dealers.
Installation
43