Miele W 931i Operating Instructions Manual page 31

What to do if, . . .
. . . one of the following
lights is flashing:
– "Soak / Pre-wash"
– "Main wash"
– "Rinses 1 - 2
– "Rinse 3
. . . the "Rinse hold" light
flashes?
. . . the "Final spin" light is
flashing:
. . . the "ON" indicator light
is flashing:
. . . the washing is not spun
satisfactorily:
. . . the machine shakes
during the spin cycle:
. . . the light rings do not il-
luminate:
. . . in spite of adequate
water supply the water flows
slowly into the machine:
Cause . . .
There is a fault.
The spin speed selector has
been set to "Rinse hold".
The final spin has not taken
place The machine detected an
imbalance.
Programme locking is activated.
There was an attempt to alter
the programme.
The spin speed selected was
too low.
The load was not distributed
sufficiently evenly in the drum.
Laundry was spun at a reduced
speed to protect the machine.
The fluff filter is clogged.
The four feet are not resting
evenly on the floor.
The bulb has gone.
(This in no way affects the
machine's function).
The filter in the water inlet
system is blocked.
Problem solving guide
Remedy . . .
Start the programme again. If
the light starts flashing again,
call the Service dept.
Select a spin speed setting (or
Without final spin).
–
Loosen the laundry load.
–
Turn the programme selector
to "Spin".
–
The spin speed appropriate
for the programme should be
selected.
Reselect the programme
originally chosen.
Select a higher spin speed next
time.
Mix large and small items in a
load to avoid imbalance.
Clean the fluff filter.
Level the machine (See Section
on Installation).
Changing the bulb requires a
Service call.
Clean the water inlet filter.
31