Table of Contents
Advertisement
RangeMax NEXT Wireless Access Point WN802T Reference Manual
SSID and WEP/WPA Settings Setup Form
For a new wireless network, print or copy this form and fill in the configuration parameters. For an
existing wireless network, the person who set up or is responsible for the network will be able to
provide this information. Be sure to set the Regulatory Domain correctly as the first step.
•
SSID: The Service Set Identification (SSID) identifies the wireless local area network.
NETGEAR is the default WN802T SSID. However, you may customize it by using up to 32
alphanumeric characters. Write your customized SSID on the line below.
___________________________________
Note: The SSID in the wireless access point is the SSID you configure in the wireless adapter
card. All wireless nodes in the same network must be configured with the same SSID,
•
Circle the type of Security Authentication used in your wireless network, and then fill out the
appropriate required encryption parameters:
WEP,
WPA-PSK,
•
WEP Encryption Type:
Circle one: Automatic or Open System
Note: If you selected Open System, the other devices in the network will not connect unless
they are set to Open System, and have the same keys in the same positions as those in the
WN802T.
•
WEP Encryption Keys:
Circle one: 64 or 128 bits. (Enter all four keys for the Key Size chosen.)
Key 1: ___________________________________
Key 2: ___________________________________
Key 3: ___________________________________
Key 4: ___________________________________
•
WPA Security Encryption for WPA-PSK, WPA2-PSK or WPA-PSK + WPA2-PSK.
Record a Passphrase between 8 and 63 characters:
Passphrase: ___________________________________
Use the procedures described in the following sections to configure the WN802T. Store this
information in a safe place.
.
3-4
WPA2-PSK, WPA-PSK + WPA2-PSK
v1.3, August 2006
Wireless Security Settings
Advertisement
Table of Contents
