Table of Contents
Advertisement
Configuring the RangeMax NEXT
Before installing the RangeMax NEXT Wireless Access Point, you should make sure that your
Ethernet network is up and working. You will be connecting the access point to the Ethernet
network so that computers with 802.11Next/b/g or 802.11b/g wireless adapters will be able to
communicate with computers on the Ethernet network. In order for this to work correctly, verify
that you have met all of the system requirements, shown on
To log into the RangeMax NEXT:
1. Prepare a computer with an Ethernet adapter. If this computer is already part of your network,
record its TCP/IP configuration settings.
2. Turn on your computer and configure your computer with a static IP address of 192.168.0.210
and 255.255.255.0 for the Subnet Mask.
3. Connect an Ethernet cable from the WN802T to the computer.
4. Connect the power adapter to the WN802T and verify the following:
•
The PWR power light goes on.
•
The Ethernet port of the wireless access point is lit when connected to a powered on
computer.
•
The WLAN LED should be blinking.
Setting Your Basic LAN Settings
The following sections describe how to log in to the wireless access point and to configure your
basic LAN settings.
To configure the WN802T for LAN access:
1. Connect to the WN802T by opening a browser window on your PC and entering http://
192.168.0.233 in the address field. The WN802T login screen will appear.
2. Enter admin for the user name and password for the password, both in lower case letters.
Installation and Configuration
RangeMax NEXT Wireless Access Point WN802T Reference Manual
v1.3, August 2006
"System Requirements" on page
1-2.
2-3
Advertisement
Table of Contents
