Iphone/Ipod Connection (Sold Separately); Remove The Iphone/Ipod; Usb Memory Connection (Sold Separately); Connect Usb Memory - Alpine CDA-117 Owner's Manual

iPhone/iPod Connection (sold separately)

Connect USB cable to an iPhone/iPod with Interface cable for iPod.
Interface cable for iPod (supplied)

Remove the iPhone/iPod

Remove the iPhone/iPod from Interface cable for iPod.
Notes
• After changing the unit to a source other than the USB iPod, remove the
iPhone/iPod. If the iPhone/iPod is removed in the USB iPod mode, data
may cause damage.
• If sound is not output or the iPhone/iPod is not recognized even when
the iPhone/iPod is connected, remove the iPhone/iPod once, then
connect it again, or reset the iPod.
• Do not leave the iPhone/iPod in a vehicle for a long time. Heat and
humidity may damage the iPhone/iPod and you may not be able to play
it again.
USB Memory Connection (sold
separately)

Connect USB Memory

Connect the USB cable to the USB connector of the unit, and then
secure the connection using the lock case supplied with USB cable as
shown below.
This unit
USB Connector

Remove USB Memory

Pull out USB Memory squarely from the USB cable.
This unit
USB Connector
USB cable
USB Memory
(sold separately)
lock case
Cable(Supplied)
USB Memory
(sold separately)
Cable(Supplied)
Notes
• When removing USB Memory, pull it out straight.
• If sound is not output or USB Memory is not recognized even when
USB Memory is connected, remove USB Memory once, then connect it
again.
• Change to a source other than the USB Memory mode, then remove the
USB Memory. If the USB Memory is removed in the USB Memory
mode, data may be damaged.
• Route the USB cable away from another cables.
51
-EN